Return Policy
The VAC SWITCHER-D Suction Controller is a sleek solution to the challenge of switching dust extraction between two tools or bleeding excess suction. It is ideal for use in small or large workshops, or on-site, and provides full control over the ratio of airflow through each port.
Simple and intuitive sliding adjustment
Control the amount of suction going to each port simply by sliding Suction Controller left or right. Get full suction at either end, or position Suction Controller anywhere in the middle to share suction with both ports. This is ideal for tools with two dust extraction ports like routers, for bleeding excess suction when working with sanders and sanding blocks, and for sharing the dust extractor with another user.
Maximize one dust extractor and save time and money
Two workshop vacuums cost twice as much, weigh twice as much, take up twice as much space, and require twice as much maintenance. Suction Controller allows you to switch between tools in a flash so your workflow isn't interrupted. No more searching for hose ends and no more lost time exchanging hoses. Don't double your investment. Get a Suction Controller instead.
Compact and minimal design
Space is valuable. Whether you work in a condo, basement, garage, mobile workshop or other small shop, you fully understand. If your dust extractor lives besides or under your bench, you understand. Bulky things are hard to store, harder to work around, and more likely to be damaged. For a mobile dust extractor, a long Y-splitter is a big space waster.
The VAC SWITCHER-D (D stands for “direct”!) is simple and compact, adding only a couple inches to the length of the dust extractor with no downsides compared to a conventional Y-splitter. Further, once installed, it looks like part of the tool.
Better than a Y splitter
Y splitters direct suction two ways so you can have two tools connected at once. That means, both tools have the same amount of suction which doesn’t make sense, since tools like saws and routers require more airflow than ones like sanders and joiners. Further, unless you remove a hose and cap an inlet, suction is ALWAYS flowing both ways. So, if you’re hopping back and forth between two tools, you’re only getting half the suction at each. That is far from optimal.
VAC SWITCHER-D Suction Controller allows you to connect two hoses AND gives you complete control over how the suction is directed.
- 100% left, 0% right
- 85% left, 15% right
- 66% left, 34% right
- 50% left, 50% right
- 24% left, 76% right
- 0% left, 100% right
or any other ratio. It’s up to you.
Easy and secure tool-free installation
VAC SWITCHER-D Suction Controller mounts directly to your workshop vacuum without tools. The 50mm (2 inch) port connects to most dust extractors and shop vacuum systems without adapters or tape shims. The precision taper fit allows secure mounting without tools. All that’s required is a good push for a secure connection. In fact, the fit is so secure that in our testing, we found we could pick up the entire dust extractor by the hose.
System approach and quality throughout
Systems work. When values are aligned, everything works together. VAC SWITCHER-D Suction Controller is designed to integrate seamlessly with your workshop vacuum and hoses. Each VAC SWITCHER-D is made of tough, plastic with stainless steel hardware. Designed in Canada. Made in Canada. Assembled in Canada.
